Seed Tree

One of the most serious forest management problems is a lack of proper regeneration. This is especially true on private timberlands. Unless a stand of desirable crop trees is regenerated on these lands, all the management options available are relatively useless. It all starts with regeneration, but many timberland owners do not realize they may have several options and should think about regeneration work long before the harvest. The reasons for not regenerating vary, and for the most part, are not valid. One of the most common reasons given is the belief that trees will regenerate themselves with no human assistance; this is true. But without active regeneration efforts, control is lost over what species will occupy the site or how long it may take for trees to cover the area. Another major concern in regeneration is the cost. While money certainly is a valid concern, it should not be prohibitive to all regeneration options. When timberland owners learn the cost of site preparation, seedlings, and planting could be $150 to $200 per acre, many of them immediately stop considering any regeneration work. Does regeneration always cost so much? The answer is no, but the alternatives to high-cost systems require planning and effort from the timberland owner or forest manager before harvesting.

Regeneration alternatives are be determined by:

• What is currently occupying the site,
• What is desired on the site, and
• When the regeneration efforts will begin.

The key to regeneration is to manage your stands in such a way you have alternatives, then use the most cost-effective system for the desired crop.

Seed Tree Regeneration

The seed tree system is a harvest/regeneration activity in which an appropriate number of individual trees are left across an area to provide seed for the production of the next crop of trees. This method is perhaps the best choice for the natural regeneration of species that develop well in full sunlight. It is important to evaluate any given stand to determine whether or not seed tree cutting is a good alternative. If you have the desired species of adequate quality, then with proper management, seed tree cutting can work successfully on most timberlands. Research has shown that seed tree cutting does not improve desirable hardwood regeneration in most situations. However, a clearcut harvest is an effective and efficient method to naturally regenerate a hardwood stand.

Preharvest Activities

For seed tree cutting to work well, you must control undesirable vegetation to allow the desired seedlings to establish. This work usually starts 4 to 5 years before harvest, with annual or biannual prescribed burns (in pine stands only) that will give some control of undesirable species and also prepare a seedbed. It is important to remember that most light-seeded species require the mineral soil to be exposed to have proper germination and seedling establishment. Injection or other timber stand improvement (TSI) methods should be used on larger stems that cannot be controlled with burning unless they are to be sold in the harvest. When the preharvest preparation activities are complete, the timberland owner is ready to mark the trees to be left for seed production.

Desirable Seed Trees

A timberland owner wants to leave the absolute best trees of the desired species on the site. The following characteristics are desirable for all seed trees: tall, straight, well-pruned, well-developed crown, average seed producer, disease free, and superior volume growth. Volume production is extremely important and, since most species used with this method develop in even-aged stands or even-aged groups, trees can be compared to others in the immediate area to evaluate their total growth and development. Historically, timberland owners have not been actively involved in selecting seed trees, and poor-quality stems were left, resulting in poor regeneration from application of the method. Overall, you must leave the best trees available on the site. If you do not have these  superior  trees available on the area, use another form of regeneration to start the next stand. With proper management and careful thinning during the next rotation, seed tree cutting should be a viable option when regeneration is next required.

How Many Trees To Leave?

* You may want to leave an extra 2-4 trees/acre for potential loss of seed trees due to windthrow, bark beetles, ice damage, etc.

Distribution of Trees

Select and mark trees with adequate distribution to provide seeds fully to the entire area. The direction of the prevailing wind at the time of seed fall dictates (to a large extent) the distribution and location of the seed trees. Seed trees should be left along the upwind boundary of the prevailing wind. Conversely, no seed trees are needed on the edge opposite from the direction of the prevailing wind. Perhaps the easiest way to approach the problem of seed-tree distribution is to consider them in terms of rows that run perpendicular to the prevailing wind. These rows can be spaced approximately two times the height of the trees themselves. Trees within a row should be spaced the same as their average height. For example, if the average seed tree height is 75 feet; the rows of these seed trees should be about 150 feet apart and the distance between the trees within these rows would be 75 feet.

Postharvest Activities

After harvest activities are completed, another prescribed burn helps reduce the debris load on the site and make final preparations of the seedbed. It is important to note that this burning should be before seed fall, which typically occurs in late October or November in the South. You don't want to burn the seeds after they have fallen! Evaluate seed tree areas during the winter following the first postharvest growing season. By doing this work in the winter, it is easier to see the tiny green seedlings. As soon as adequate regeneration in terms of density and stocking is established, remove the seed trees. If seed trees are not removed, they will have a negative impact on the development of the established regeneration. They will also continue to disseminate seeds across the area, and lead to overstocking of seedlings. On small parcels of land, it may be difficult to market these seed trees. It is essential to remove them or even cut them and leave them, if necessary, to promote the development of the next crop of seedlings. If adequate regeneration is not present after two years, you need to burn the site to control undesirable vegetation and prepare a new seedbed. This could happen if your planned regeneration year turns out to be an extremely droughty period, or if an unexpected flood takes the seeds away from the area.

Application

Most forested areas can be successfully regenerated using the seed tree method; however, there are exceptions. Seed tree regeneration should not be used in areas that flood frequently, on those areas with steep topography, or shallow soils. On areas that flood frequently, the seeds will be washed away, and areas with steep topography may have heavy rainfalls that cause the seeds to wash down slope. In the areas where seeds collect, seedling density is unacceptably high and low density of seedlings is observed across the remainder of the area. Areas with extremely shallow soils will suffer from excessive damage to seed trees due to windthrow. Remember, these trees are highly vulnerable to the forces of nature once they are left on an area with no surrounding vegetation. This method works best in areas of fairly level topography with adequate soil moisture during the growing season for seedlings to survive and develop.

Summary

Overall, seed tree regeneration presents an excellent opportunity for most timberland owners who want to grow pine or other light-seeded species. It is important to remember two major items before you attempt to use seed tree regeneration. First, regeneration is not free. It is much less expensive than many of the artificial regeneration alternatives, but the prescribed burning and timber stand improvement work costs money. In addition to the out-of-pocket costs, the timber sale revenue may be less, due to the seed trees left. The latter cost or loss of revenue may be small and/or negligible in many cases, but it should be analyzed. Second, timberland owners should not try to use this method if they currently do not have a good quality stand of trees on the area. Trying to take a poor quality stand and regenerate a high quality stand using the seed-tree method typically results in disaster. The seed tree method has limitations, but it also presents great opportunities. Working within those limitations and realizing the opportunities benefits your forest resources.